JRC JMR-9272-S - Checking Route Data; Checking a Route Based on the Safety Standards

Section 9 Route Planning 9-64
9.9 Checking Route Data
Route data is constantly checked based on the safety standards and limits.
These items are checked on the [Check Route] dialog box.
The [Check Route] dialog box appears by clicking on the [Show Route Check] button on the Route
Planning bar.
9.9.1 Checking a route based on the safety
standards
The result of safety check is displayed on the [Safety check] tab.
When safety errors are detected, the number of errors is displayed on the count badge. When the error
count exceeds 999, "More" is displayed instead of the count.
The list of Cause and Result of the errors that were detected is displayed for each WPT prior to and
following the error occurrence point. The following causes are displayed.
Cause
SpeConAre(Traffic separation zone)
SpeConAre(Traffic crossing)
SpeConAre(Traffic roundabout)
SpeConAre(Traffic precautionary)
SpeConAre(Two way traffic)
SpeConAre(Deeper water route)
Approval status (Result)
Re-check button
WPT
Check box
Count badge
Cause
[Safety contour] box
[Jump] button
[Reset] button
[Disregard] button