JRC JMR-9272-S - Creating an Object(at Manual Update of ARCS)

14-33 Section 14 Creating a User Chart/ Updating a Chart Manually
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
14.5 Creating an Object(At Manual Update
of ARCS)
This section describes the procedures for changing the parameters of the object after creating the
object on the user chart or chart during manual update.
Note
After automatic sailing, the mark/line may be shifted depending on how the cursor is placed on the
target at the input.
To prevent the shift, place the cursor on the front edge of the target.
• Input method that does not cause shift (place the cursor on the front edge of the target)
• Input method that causes shift (place the cursor on the center of the target)
SHM
Target
Cursor
Own ship's
position
SHM
Tar
g
et
Cursor
Own ship's
position