Section 5 Basic Operation of the Radar 5-6
5.2.2 Exiting radar operation
1 Click on the Standby/Transmit switch button in Radar system information.
Radar transmission stops and the rotation of the radar antenna stops.
The display of the Standby/Transmit switch button changes from "Transmit" to "Standby".
Memo
If observation using the radar is being scheduled within a comparably short period of time,
keep this state. Observation can be started immediately by just clicking on the
Standby/Transmit switch button.
2 Press the Power button on the operation unit.
The power to this equipment is turned OFF.
Before starting maintenance, turn off power. Cut off all the power
supplies to the equipment.
Some equipment components can carry electrical current even after the
power switch is turned off, and conducting maintenance work may result
in electric shock, equipment failure, or accidents.
When turning off the power supply, do not hold down the power button of
the operation unit.
Otherwise, a trouble may occur due to termination failure.
To Next Page
Loading...
