9-73 Section 9 Route Planning
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
Note
The file type of the file to be imported can be selected in the [File Type] combo box.The file types
that can be imported are as follows.
.rtn: Displays a route file (normal).
This file is used for ECDIS (JAN-701B/901B) and Chart Radar (JMA-900B)
.rta: Displays a route file (TCS route).
This file is used for ECDIS (JAN-701B/901B) and Chart Radar (JMA-900B)
.rtm: Displays a route file used in this equipment.
.rtz: Displays a route file (the route plan exchange format specified in IEC61174). RTZ version
1.0 and RTZ version 1.1 are supported.
.csv: Displayes a route file in CSV format.
*(Wildcard): Displays all the files that can be imported.
When importing a route file created by another company's device, be sure to check the route file
with the route planning function before using it. If the XTL, Arrival Radius, PlanSpeed, Sail, Turn
Radius, and Time Zone of the route file to be imported contain values outside the set range, the
default values will be replaced and imported. (If a csv format route file containing values outside
the set range is imported, an import error will occur. The value does not replace the default value)
9.11.2 Exporting a route file
1 Specify the "Drive", the "Folder", the "File name", and the "File Type" that stores the
file to be exported.
2 Click on the [OK] button.
The route file that is currently opened is exported.
Press the [X] button to cancel the exporting of a file.
Note
When .rtz is selected, the route file will be exported in RTZ version 1.0 format.
To Next Page
Loading...
