Operation
4-57
4.7 Display of telex communication logs
The telex communication is saved automatically as the log, and the reference is available later.
■ Procedure ■
1
1
1
.
.
.
If displaying the message of "Press Enter key to get the access right in the NBDP
mode…" on the data terminal, press Enter key on the keyboard.
The operation of the data
terminal becomes possible in
the telex mode, except when
the controller is used.
2
2
2
.
.
.
On the main menu and the dropdown menu, select Service Call logging history with
Enter key.
The list of the log as shown at
right is displayed.
3
3
3
.
.
.
Move the cursor to the objective file referring to the timestamp and press Enter key to
view it.
The file content on the viewer scrolls by the ↑↓ key.
To close the file viewer, press the ESC key.
The maximum size of a log file is 8192 bytes. When exceeding it, the excess data
are stored in another file.
Note
[TEL] Tx= 2174.50kHz/Rx= 2174.50kHz USB
File Tune Connect Service System Help
STATUS INFO
[No scanning] TUNER :[READY]
Tx.POWER :[HIGH]
Press Enter key to get the access right in the NBDP mode...
Scanning info
Tuner/Tx.POWER
Last status message
MF
HF
To Next Page
Loading...
