JRC JSS-2150 - Telex Communication Screen

Names and Functions
2-11
2.4.2 Telex communication screen
1. Indicates the operating condition of the
telex communication from the left of each
segment as follows.
1） In the autotelex mode, when the free
channel signal of the coast station is
detected, indicates the “Free Sig”.
2） Indicates the communication mode
(ARQ/CFEC/SFEC).
※ Indicates “ST-BY” in the standby
condition.
3） Indicates “Calling” at the master
station, and “Called” at the slave
station.
4） Indicates “Send” at the information
sending station, and “Receive” at the
information receiving station.
5） Indicates "Phasing" while calling and
connecting the communication
channel and “Rephasing” while
reconnecting the channel after the
channel is disconnected due to the
channel condition in ARQ mode.
6） Indicates “Repeat” in ARQ mode if
requested to send the each block or
the control signal again.
7） Indicates “Traf” while sending or
receiving information and “RQ” while
sending or receiving RQ signal.
2. Indicates the telex message or the name
of the executed function key.
3. Indicates the usable function keys guide.
Each meaning is as follows.
 F2 WRU ： Requests the answer-
back code to the
corresponding station.
 F3 Hereis ： Sends the answerback
code of own station.
 F4 TMS ： Sends the date and the
time information.
 F5 Over ： Exchange the sending
and the receiving
condition.
 F6 POLL ： Acquires the sending
right if the correspond-
ing station (sending)
tries to finish the
communication in ARQ
mode.
※ It is available only when the
corresponding station is using the
modem made of our company.
 F8 F.Send ： Sends a message file.
 F10 Stop ： Finishes the telex
communication.
1
2
3