JRC JSS-2150 - Printer (NKG-800)

Options Operation
10-8
10.6 Printer (NKG-800)
CAUTION
The print head of the NKG-800 printer may be very hot after printing. Do
not touch the print head of the printer. Make sure that the print head is cool
before replacing the paper or cleaning the print head.
Do not use the NKG-800 printer if there is no ink ribbon cartridge or paper.
Do not twist the ink ribbon when installing the ink ribbon cartridge.
Before opening and closing the cover of the NKG-800 printer, turn off the
printer. Wait more than 2 seconds after turning the printer off before turning it
back on again so it can initialize correctly.
The following shows the functions of the operation panel.
P.PARK FF LF NLQ ONLINE
Paper Park
Rewinds the roll
paper.
Feed Form
Feeds paper one
page at a time.
Line Feed
Feeds the paper
one line at a
time.
High-quality
Printing
Switches the
printer to the
high-quality
printing mode.
Printer Ready
Setting
The printer is
ready for
printing when
the lamp is lit.
Note 1: Before performing P.PARK/FF/LF/NLQ, press ONLINE to set the printer offline (lamp out).
Note 2: When the printer runs out of roll paper, the P.OUT lamp lights and the printer
automatically goes offline.
Platen
Paper is fed in contact
with this platen when the
friction lever is pushed
towards the back.
Power switch
Operation
panel
Roll paper cover
Roll support cover
Prevents printed roll paper
from being wound back in.
Roll paper
Roll paper stand
Roll bar
Passes through
the printing roll
paper.
Roll paper cutter
Paper feed knob
Friction lever
When replacing the roll paper,
pull this lever towards the front
before inserting the paper, and
return it towards the back after
paper is inserted.
Printer cover
Print head
Contacts the roll
p
a
p
er for
p
rintin
g
.