JRC JSS-2150 - Transferring User Channel Data to Another Controller

Settings & Registrations
5-8
5.3.5 Transferring user channel data to another controller
When 2 controllers are connected, user channel table can be transferred from the controller
having access rights to another controller (monitor condition).
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select 7.3 My
controller.
2
2
2
.
.
.
Move the cursor to 5. Data transfer with
the numeric keypad or jog dial and press
ENT.
The popup screen as shown at right is
displayed.
3
3
3
.
.
.
Press ENT to confirm the selection.
 The popup screen as shown at right is
displayed to indicate the controller's
status for forwarding.
 The screen at right (below) is displayed
on the monitor.
If OK is selected or the screen is left as
it is for 10 seconds, transferring of
stored information is started.
4
4
4
.
.
.
Forwarding of stored information is
started.
 During forwarding, the popup screen as
shown at right is displayed.
 The screen at right (below) is displayed
on the monitor.
 The previous screen is returned to when
forwarding is completed.
To cancel forwarding midway,
press the CANCEL key or ENT.
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
5.Data transfer
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
5.Data transfer
Data sending...
[Cancel]
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
5.Data transfer
Wait a moment, please.
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
6.Menu shutdown :10min
7.CH search ref :40
8.Frequency digits :7 only
5.Data transfer
OK to transfer the
user channels to
another controller?
[ OK ]
[Cancel]
Note
[Display on monitor]
OK to update this
user channel table?
[ OK ] [Cancel]
[Display on monitor]
Updating the table...
[Cancel]