Settings & Registrations
5-23
5
5
5
.
.
.
When the cursor is located on Set, press Enter key to set the value and close the
popup screen.
6
6
6
.
.
.
After completing the every input, move the cursor to Set and press Enter key to save
and finish the registration.
- When selecting the Initialize with the cursor and pressing Enter key, the every
accessible item is reset to the factory default setting.
- The content of each item and the factory default setting values are as follows.
Item Setting contents
Initial
value
Remarks
ARQ/FEC 4- or 5-digit Self-ID
Registers the SELCAL number.
※ 4-digit is for the coast station.
-----
When setting this item,
contact our company or
agency.
GFEC 4- or 5-digit Self-ID
Registers the group ID.
※ 4-digit is for the coast station
-----
ARQ/FEC 9-digit Self-ID
9-digit SELCAL number for
reference.
----- Common with the DSC
GFEC 9-digit Self-ID Registers the 9-digit group ID. -----
Answerback
Registers the answerback code
used with WRU and Hereis.
-----
When setting this item,
contact our company or
agency.
Max. FEC error rate
Sets the permissible error rate that
occurs during CFEC receiving.
30 %
Max. automatic call series
Sets times to retry calling a station
if failed to call the station using the
CALL function.
2 Optional
Collective FEC receiving
Sets ON/OFF of the CFEC or SFEC
receiving.
ON
Time duration for AUTO
Sets the interval time until retrying
if failed to call a coast station using
the AUTOTELEX function.
10 min Optional
Restart
Sets ON/OFF of the rephasing
function if disconnected the
communication in ARQ mode.
ON
Finite start/restart
Sets ON/OFF of the limit of the
ARQ call times, which is 128 times
for phasing and 32 times for
rephasing.
ON
Transmitter pre-key time
Sets a period between key on and
starting the signal output.
10 ms
Note
To Next Page
Loading...
