EasyManua.ls Logo

JRC JSS-2150 - Page 208

JRC JSS-2150
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Options Operation
10-12
The following shows the functions of the operation panel.
On Line ꞏꞏꞏꞏꞏꞏ When the On Line lamp is lit, the printer is ready for printing.
And the following operation is available in this condition.
- Preview : Feeds the paper some lines temporally to
show the printed lines hidden under the cover.
To undo it, repress this key. Also, cannot
print during preview.
Off Line ꞏꞏꞏꞏꞏꞏ Sets the printer to the offline state if pressing during the online
state. During the offline state, the On Line lamp is turned off and
the following operations become available. To undo it, repress
this key.
- Tear Off : Inserts line feeds to cut the paper at the end
of the printed line.
- LF/FF : Feeds the paper one line if pressing a moment
or feeds the paper one page if holding down a
few seconds.
- Eject : Reverses the paper back out to eject it.
Moreover, to set the printer to the adjustment mode and change
the following conditions, hold down the Off Line key for three
seconds. To undo it, repress this key for a moment.
- Mode : Selects the Mode1 or Mode2.
Note) Always set to the Mode1. Additionally,
the Custom is not accessible.
- Micro Adjust : Fine-tunes the feed length of the Preview.
- When the paper runs low, the Paper Out lamp starts blinking with beeping.
- When the printer runs out of roll paper, the Paper Out lamp lights and the printer
automatically goes offline in the same way as the friction lever pulled to the front.
- When pressing the Eject key in the offline state, the Paper Out lamp lights even
though still remains the roll paper. In this case, the friction lever or the power
switch operation can recover the condition, but to avoid troubles such a paper
jam, basically remove the roll paper from the printer.
- Do not cut off the paper just after feeding lines by pressing the Preview key. Always use the
Tear Off key when feeding lines to cut off the paper.
Loading the printer paper
1
1
1
.
.
.
Turn the printer OFF, open the printer cover
and remove the roll paper cover.
At this step, pull the friction lever towards the
front.
Note
Roll paper cover
Printer cover
Friction lever

Table of Contents

Other manuals for JRC JSS-2150

Related product manuals