Operation
4-29
(4) Using channel lists
Besides the procedure above, user channels (except the telex mode) and ITU channels can also
be set from the channel lists (5.1 User channel list or 5.2 ITU channel list). This section explains
how to set channels that are already registered from the user channel list.
See "5.4 Registering user channels" for how to register frequencies to user channels.
■ Procedure ■
1
1
1
.
.
.
Press the MENU key, and through
hierarchical menus, select 5. Radio
operation.
2
2
2
.
.
.
Select 1. User channel list and press ENT.
The user channel list index (group list) as
shown at right is displayed.
3
3
3
.
.
.
Select the intended channel group and press
ENT.
The user channel list as shown at right is
displayed.
4
4
4
.
.
.
Select the channel to set and press ENT.
The user channel settings are complete, the
status display is displayed.
TEL
U01- 001
ID 431001234 23:59(UTC)
Pos 89ﾟ59.0123'N
179ﾟ59.6789'E@23:59
S
IG
12 -S N2
RX
4357.00
kHz
TX
4065.00
kHz
W
KR
2
4
6
8
12
16
A COMM
Communicating on
TEL Rx: 4357.00/Tx: 4065.00kHz
Tip)Use FUNC to change op area.
[HLD][END]
D
UP
G
PS
5) Radio operation
1.User channel list
2.ITU channel list
3.Mode :TEL
4.Receiver
5.Transmitter
6.ITU CH of RR2012 :Apply
0.Back
5.1)User channel list (index)
No CH group name Type
01 JRC Tokyo TEL
02
03
04
05
06
07
08
Pacific ABC CW
Note
To Next Page
Loading...
