JUKI DDL-8700A-7 - Material End Sensor Connection

– 49 –
16. Connection of the material end sensor
1) Open the cover referring to
"
#
-13.
Removing
the rear cover" p.46
.
2)
Connect the connector of material end sensor to
connector
1
(CN54 : 4P).
3) Assign CN54 to the material end sensor input
referring to
"
#
-8-
8
. Selection of the optional
input/output function (Function setting No.
12) p.34
.
4) To use the material end sensor, set up the sen-
sor functions on the control box through the
function setting procedure. Selectable functions
and the corresponding selection numbers are as
follows:
・
Material end sensor function (function setting No. 2)
The material end sensor is enabled.
0: Material end sensor is not used.
1: Material end sensor is enabled.
・
Thread tr
imming function by means of the mate-
r
ial end sensor (function setting No. 3)
The automatic thread trimmer is activated after
the detection of the material end.
0: Automatic thread trimming is not carried out.
1: Automatic thread trimming is carried out.
・
The number of st
itches after the activation of the
material end sensor (function setting No. 4)
The number of stitches to be sewn until the sew-
i
ng machine stops after the material end sensor
has detected the material end can be specied.
Data setting range: 0 - 19 <1/stitch>
・
One-shot funct
ion (function setting No. 76)
The one-shot operation until the material end is
detected can be set.
0: One-shot operat
ion is not carried out.
1: One-shot operation is carried out.
(Caution) 1. Be sure to turn OFF the power before
connecting the connector.
2. For the use of the material end sen-
sor, refer to the Instruction Manual
attached to the material end sensor.
JUKI genuine part number Connector HK042310040
Pin contact HK042340000
1
2
1
3
5
4
0
7 6
Pin No. Signal name Remarks
1 +12V
Power supply
is selected
according to the sensor
used.
2 +5V
3 OPT_S
Sensor
input is assigned to
the material end sensor.
4 GND
1