6
543
7
A part of function setting items can be easily changed in the normal sewing state.
(Caution) For the setting of functions other than those covered in this part, refer to "
#
-6. Setting of func-
tions" p. 28.
[One-touch setting procedure]
1) Keep
switch
7
held pressed for one second
to place the panel in the function setting mode.
2) Change over the item to be set by using
switch
3
or switch
4
. Then, the set value
can be changed by using switch
5
and
switch
6
.
3) To return to the normal sewing state, press
switch
7
.
(Caution) The setting is conrmed by pressing
switch
7
. On
e-shot automatic sewing, material
edge sensor, thread trimming by the material
edge sensor and the number of stitches of the
material edge sensor are not displayed in the
default setting at the time of delivery.
1
Thread trimming function (
)
: Thread trimming operation is not performed (solenoid output prohibition: Thread trimmer, wiper)
: Thread trimming operation is effective.
2
Wiper function (
)
: Wiper does not operate after thread trimming.
: Wiper operates after thread trimming
3
One-shot automatic stitching function (
)
:
One-shot automatic stitching function is ineffective.
:
One-shot automatic stitching is effective.
(Caution) This function is rendered effective when the material end sensor function is set. It is not pos-
sible to prohibit the one-shot operation during overlapped sewing operation. The number of revolution
is the value which is set for setting No. 38.
4
Setting of the max. speed of stitch (
)
The highest speed of stitch of the machine head is set. The upper limit of the set value differs with the
type of machine head to which the SC is connected.
Setting range : 150 - Max. value [sti/min]
5
Material end sensor function (
)
: Material end sensor function is ineffective.
: Once the material end is detected, the sewing machine stops running after having sewn the
number of stitches set with
7
(
).
* This function is rendered effective when the material edge sensor is set with function setting No. 12.
6
Thread trimming function by material end sensor (
)
: Automatic thread trimming function after the detection of material end is ineffective.
: Once the material end is detected, the sewing machine performs thread trimming after having
sewn the number of stitches set with
7
(
).
* This function is rendered effective when the material edge sensor is set with function setting No. 12.
7
Number of stitches for material end sensor (
)
The number of stitches to be sewn from the detection of material end to the stop of the sewing machine
Number of stitches that can be set: 0 to 19 (stitches)
(Caution) This function is rendered effective when the material end sensor function is set.
If the number of
stitches specied is inadequate, the sewing machine can fail to stop within the preset number of stitches
depending on the number of revolutions of the sewing machine.
8
Adjustment of quantity of light of LED light
（
）
The quant
ity of light of the LED light is adjusted
Setting range : 0 to 100
4. One-touch setting
To Next Page
Loading...
