JUKI DDL-8700A-7 - Connector Layout

– 53 –
3. Connector layout drawing
Following connectors are prepared on the front face of MAIN board.
Connect the connectors coming from the machine head to the corresponding places so as to t the devices
mounted on the machine head.
1
CN12 : Connector for relay cord
2
CN34 : Pedal sensor
3
CN30 : Motor encoder
4
CN60 : Mach
ine head panel
5
CN38 : CP/IP panel
6
CN39 : Stand
ing-work machine
7
CN57 : Product
ion control
8
CN54 : OPTION INPUT
9
CN50 : OPTION I/O
!0
CN
11 : Regenerative resistance
!1
CN52 : CPU INSYSTEM
!2
CN53 : JTAG
!3
CN36 : Mach
ine head solenoid
!4
CN37 : Presser foot l
ifter solenoid
!5
CN58 : Fan
!6
CN55 : LED l
ight
!7
Motor cable
!8
Panel cable
!9
Power cord
WARNING :
• To protect against personal injury resulting from abrupt start of the sewing machine, be sure to
turn the power OFF, unplug the machine and wait for ve minutes or more before connecting the
connectors.
•
To prevent damage of device caused by maloperation and wrong specifications, be sure to
connect all the corresponding connectors to the specied places. (If any of the connectors is
inserted into a wrong connector, not only the device corresponding to the connector can break
but also it can start abruptly, inviting the risk of personal injury.)
•
To prevent personal injury caused by maloperation, be sure to lock the connector with lock.
• As for the details of handling respective devices, read carefully the Instruction Manuals supplied
with the devices before handling the devices.