JUKI DDL-8700A-7 - Function Setting Procedures

– 28 –
6
543
6
543
7
Functions can be selected and specied.
(Caution) Refer to the Instruction Manual for each operation panel for how to operate sewing patterns us-
ing other operation panel than the built-in panel of the machine head.
1) Turn ON the power with switch
7
held
pressed.
(The
item which has been changed during the
previous work is displayed.)
* If the screen display does not change, re-carry
out operation described in step 1).
(Caution) Be sure to re-turn ON the power switch
when one or more seconds have passed after
t
urning it OFF. If the power switch is re-turned
ON immediately after turning it OFF, the sewing
machine may fail to operate normally. In such a
case,
be sure to turn ON the power switch again
properly.
2) To move the setting No. forward, press
switch
4
.
To move the setting No. backward,
press
switch
3
.
(Caution) If the setting No. is moved forward (or
backward), the previous (or subsequent) content
of the setting is conrmed. Be careful when the
content of a setting is changed (when the
/
switch is touched).
Example) Changing the maximum number of revolu-
tions (setting No. 96)
Press
switch
3
or switch
4
to call set-
ting No. "96."
The current set value is displayed on indicator
B
.
Press
switch
5
to change the sett
ing to
"2500."
*
The content of setting of the setting No. returns
to the initial value by pressing
switch
5
and
switch
6
s
imultaneously.
3)
After completion of the changing procedure, press
switch
3
or switch
4
to conrm the updat-
ed value.
(Caution) If the power is turned OFF before carry-
ing out this procedure, the changed content is
not updated. When
switch
3
is pressed, the
display on the panel changes to the previous
setting No. When
switch
4
is pressed, the display on the panel changes to the subsequent setting
No. After completion of the operation, the machine is returned to the normal sewing state by turning
OFF the power and re-turning it ON.
6. Setting of functions