JUKI DDL-8700A-7 - Page 8

– 5 –
6) Connect the power cord to the power plug.
As shown in the gure, connect the white and black
(and red) wires to the power supply side and the
green/yellow one to the grounding side.
(Caution) 1. Be sure to prepare the power plug
3
which conforms to the safety stan-
dard.
2.
Be sure to connect the ground lead
(green/yellow) to the grounding side.
7) Check that the power switch is in the OFF state.
Then, insert the power plug coming from the power
switch into the plug receptacle.
(Caution) In prior to the connection of the power
plug, re-check the supply voltage speci-
cation indicated on the power box.
Power switch
AC cable
Pedal sensor cable
3) Securely x the terminals of the AC input cord
by tightening the screws at the specied loca-
tions.
4) Close the power switch cover. Tighten screw
1
on the side face of the power switch cover.
5) Firstly attach the staple supplied with the unit as
accessories to the cable. Then, hammer them
into the sewing machine table.
At this time, attach the staples at the locations
shown in the gure.
Staples
(large)
C
able draw-out
hole
Pedal sensor
Staples (small)
Green/
Yellow
White
Black
3
WARNING :
1. Be sure to attach the ground wire (green/yellow) to the specied location (on the ground side).
2. Take care not to allow terminals to come in contact with each other.
3. When closing the power switch cover, take care not to allow the cord to be caught under it.
3ø 200V-240V
1ø 100V-120V
220V-240V
A
C 200V-240V
Black
R
ed
White
Green / Yellow
(ground wire)
Black
White
Green / Yellow
(ground wire)
AC 100V-120V
AC 220V-240V
3ø 200V-240V
1ø 100V-120V
220V-240V
Green/
Yellow
R
ed
White
Black