10
Preparing the machine / Using the machine
Thread stand
1. Insert retractable support rod (A) into thread guide support (B).
2. Draw out retractable support rod (A) to put it into the positioning
stopper until it clicks. Then, install open thread guide (C) so that it
is positioned directly above spool holder pin (D).
Positioning stopper
Thread / cones / spools
The anti-vibration cone should be
used with the wider edge at the
bottom on the spool holder pin
when sewing with cones.
Large spools
If large industrial spools are
used, position the anti-vibration
cone upside down on the spool
holder pin, i .e. with the wider
edge at the top.
Household spools
Remove the anti-vibration cones.
Place spools on spool holder
pins and push the spool caps
on with the rounded side down-
wards.
B
A
A
C
D
Turn the arrow toward you.
To Next Page
Loading...
