Julabo MC - Page 53

MC
53
in commands: Asking for parameters or temperature values to be displayed.
Command Parameter Response of circulator
in_pv_00 none Actual bath temperature.
in_pv_01 none Heating power being used (%).
in_pv_03 none Temperature value registered by the safety sensor.
in_pv_04 none Setpoint temperature („SafeTemp“) of the excess
temperature protection
in_sp_00 none Working temperature „t 1“
in_sp_01 none Working temperature „t 2“
in_sp_02 none Working temperature „t 3“
in_sp_03 none High temperature warning limit „t High“
in_sp_04 none Low temperature warning limit „t Low“
in_sp_07 none Pump pressure stage
in_par_01 none Te - Time constant of the external bath.
in_par_02 none Si - Internal slope
in_par_03 none Ti - Time constant of the internal bath.
in_par_06 none Xp control parameter of the internal controller.
in_par_07 none Tn control parameter of the internal controller.
in_par_08 none Tv control parameter of the internal controller.
in_mode_01 none Selected setpoint:
0 = Setpoint „t 1“
1 = Setpoint „t 2“
2 = Setpoint „t 3“
in_mode_05 none
Circulator in Stop/Start condition:
0 = Stop
1 = Start