Julabo MC - 14 Cleaning; Repairing the Unit

MC
57
14. Cleaning / repairing the unit
Caution:
• Always turn off the unit and disconnect the mains cable from the
power source before cleaning the unit.
• Prevent humidity from entering into the circulator.
• Electrical connections and any other work must be performed by
qualified personnel only.
To maintain the full cooling performance, clean the condenser
from time to time.
• Switch off the unit, disconnect mains power cable.
• Hold the venting grid, pull out and remove.
• Clean the ribbed condenser with a vacuum cleaner.
• Replace the venting grid.
• Switch on the unit.
Water cooled models:
In order to maintain a good condition of the cooling
compressor, the sieve in the cooling water input should be
cleaned in regular intervals.
Cleaning:
For cleaning the bath tank and the immersed parts of the
circulator, use low surface tension water (e.g., soap suds).
Clean the outside of the unit using a wet cloth and low
surface tension water.
The circulator is designed for continuous operation under
normal conditions. Periodic maintenance is not required.
The tank should be filled only with a bath fluid recommended
by JULABO. To avoid contamination, it is essential to change
the bath fluid from time to time.
Repairs
Before asking for a service technician or returning a
JULABO instrument for repair, please contact an
authorized JULABO service station.