31
5 Data logger
This chapter describes the recording of the measured data in the memory
through the data logger function. You can record data in the memory either
manually or automatically. With both methods (manual or automatic), the
measured data can be retrieved through the function menu “Memory (Fn1)”.
Data are recorded in the memory in the order of their arrival.
Memory menu “Memory (Fn1)”:
Max. number of stored data:
TDA-300: 99 measurements
TDA-3000: 9999 measurements
Data security:
In a TDA-300 the data will be lost
if the battery is empty.
After defragmentation,
the latest memory contents
will be displayed again.
If SET is pressed while YES is being displayed,
then the entire memory will be cleared and the
normal display will appear.
To Next Page
Loading...
