4.9.2 Display Messages
Display Meaning Corrective measures
Err01 Load cell signal is not stable Automatic
Err02 Capacity of the weighing system
exceeded
Automatic after load has been
removed
Err03 Gross weight is negative.
This is not permitted.
Automatic
Err04 Outside the zero range Press any key
Err06 Input signal too high Automatic after adjustment of input
signal
Err08 Adjustment outside of range
(negative)
Automatic
Err09 Adjustment outside of range (signal
too low)
Automatic
Err10 Adjustment value 2 (3) is lower
than value 1 (2)
Automatic
Err14 Switching value 2 < switching value
1
This is not permitted.
Automatic
CAL-J Calibrated version only
No action permitted
If no action is required, remove
jumper JP1.
Z
Following this action, a
complete reconfiguration
and recalibration of the
system is required.
Err98 Adjustment point must be higher
than the previous one
Automatic
Err99 Operation only permitted on power-
up unit
Automatic
---- Load cell signal is negative Raise load handler
Err_L Truck is not level
(calibrated version only)
Level the truck
Weighing system battery is empty Charge the battery
OimL Action not permitted
(calibrated version only)
Automatic
ntEP Action not permitted
(calibrated version only)
Automatic
SCALL Test path number outside of range Contact service
ESoFt Incorrect firmware combination Contact service
EConF P96 not set Set P96 according to the used
hardware
78
11.19 en-GB
To Next Page
Loading...
Need help?
General
