To Next Page

To Previous Page

1205.GB

D 2

2Battery types

The truck is equipped with the following battery types:

The battery weight is indicated on the battery data plate.

When replacing/installing the battery make sure the battery is securely located in the

battery compartment of the truck.

3 Charging the Battery

When the green LED (100%) on the battery discharge indicator is lit, the battery is

fully charged.

When the red LED on the battery discharge indicator is lit, the battery is discharged.

The truck must be charged with a stationary charger.

– Park the truck securely (see Chapter E).

Only connect and disconnect the battery and the charger when the charger is

switched off.

– Connect the charger to the battery. Then connect the charger to a suitable mains

socket (230 V ±10%).

– Charge the battery until the green LED (100%) on the battery discharge indicator

is lit.

– Pull the mains connector of the charger out of the mains socket, and remove the

charger connector from the battery connector.

Do not undertake a lift operation during charging.

To ensure a long battery life, it is advisable to run a regular compensation charge (1 x

a week). The charger must be connected to the mains for at least 12 hours.

Mains connection

Mains supply: 230 V (± 10%)

Mains frequency:50 Hz ± 4%

Charging times

The charging time can take up to 12 hours depending on the battery discharge status.

12 volt battery 60AhC5