To Next Page

To Previous Page

1205.GB

D 4

5 Battery Replacement

The truck must be parked on level ground. To prevent short circuits, batteries with

exposed terminals or connectors must be covered with a rubber mat. Place the

battery connector or the battery cable in such a way that they will not get caught on

the truck when the battery is removed.

When replacing a battery always use the same battery type. Extra weights must not

be removed and must remain in the same position.

– Turn the turn-lock fasteners (1) 90°.

– Remove the battery panel.

– Undo the terminal screws and remove the battery cable from the terminals.

Place the battery connector or the battery cable in such a way that they will not get

caught on the truck when the battery is removed.

– Remove the battery.

Installation is the reverse order. When reinstalling the batteries, make sure they are

installed in the correct position and properly connected.

– Red cable: + terminal

– Black cable: - terminal

– After installing the battery again, check all cables and plug connections for visible

signs of damage.

Before starting the truck, the battery panel must be firmly closed. Close the battery

panel carefully and slowly. Do not reach between the battery panel and the chassis.