Jungheinrich AMX Inox User Manual

0708.GB
F 10
7.5 Recommissioning
The truck may only be restored to service after cleaning or repair work, once the
following operations have been performed.
– Lubricate the truck in accordance with the lubrication schedule.
– Bleed the hydraulic system by pumping the pallet truck up completely.
– AMX-E only: Test the “Lift/Lower” button.
8 Decommissioning the industrial truck
If the industrial truck is to be decommissioned for more than two months, e.g. for
operational reasons, it must be parked in a frost-free and dry location and all
necessary measures must be taken before, during and after decommissioning as
described.
M
On decommissioning the truck must be jacked up so that all the wheels are clear of
the ground. This is the only way of ensuring that the wheels and wheel bearings are
not damaged.
If the truck is to be out of service for more than 6 months, further measures must be
taken in consultation with the manufacturer’s service department.
8.1 Prior to decommissioning:
– Thoroughly clean the truck.
– Check the hydraulic oil level and replenish as necessary (see Chapter F).
– Apply a thin layer of oil or grease to any non-painted mechanical components.
– Lubricate the truck in accordance with the lubrication schedule (see Chapter F).
AMX-E only:
– Charge the battery (see Chapter D).
– Disconnect the battery, clean it and grease the terminals.
Z
In addition, follow the battery manufacturer’s instructions.
– Spay all exposed electrical contacts with a suitable contact spray.
8.2 Action to be taken while the truck is out of service (AMX-E only)
Every 2 months:
– Charge the battery (see Chapter D).
M
Battery powered trucks:
The battery must be charged at regular intervals to avoid depletion of the battery
through self-discharge. The sulfatisation would destroy the battery.
0708.GB
F 10
7.5 Recommissioning
The truck may only be restored to service after cleaning or repair work, once the
following operations have been performed.
– Lubricate the truck in accordance with the lubrication schedule.
– Bleed the hydraulic system by pumping the pallet truck up completely.
– AMX-E only: Test the “Lift/Lower” button.
8 Decommissioning the industrial truck
If the industrial truck is to be decommissioned for more than two months, e.g. for
operational reasons, it must be parked in a frost-free and dry location and all
necessary measures must be taken before, during and after decommissioning as
described.
M
On decommissioning the truck must be jacked up so that all the wheels are clear of
the ground. This is the only way of ensuring that the wheels and wheel bearings are
not damaged.
If the truck is to be out of service for more than 6 months, further measures must be
taken in consultation with the manufacturer’s service department.
8.1 Prior to decommissioning:
– Thoroughly clean the truck.
– Check the hydraulic oil level and replenish as necessary (see Chapter F).
– Apply a thin layer of oil or grease to any non-painted mechanical components.
– Lubricate the truck in accordance with the lubrication schedule (see Chapter F).
AMX-E only:
– Charge the battery (see Chapter D).
– Disconnect the battery, clean it and grease the terminals.
Z
In addition, follow the battery manufacturer’s instructions.
– Spay all exposed electrical contacts with a suitable contact spray.
8.2 Action to be taken while the truck is out of service (AMX-E only)
Every 2 months:
– Charge the battery (see Chapter D).
M
Battery powered trucks:
The battery must be charged at regular intervals to avoid depletion of the battery
through self-discharge. The sulfatisation would destroy the battery.

Jungheinrich AMX Inox Specifications

General

Brand	Jungheinrich
Model	AMX Inox
Category	Forklifts
Language	English