To Next Page

To Previous Page

E 7

1205.GB

4.3 Lifting and depositing loads

Before picking up a load, the driver must ensure that it is correctly palletised and that

the capacity of the truck is not exceeded.

Do not lift long loads at an angle.

– AMX: Lower the fork if necessary by pressing the

handle in the “Lower” direction and then return the

handle to the neutral (N) position.

– AMX-E: Lower the fork if necessary by pressing the

button in the “Lower” direction.

– Fully insert the forks of the truck underneath the load.

Raise/Lower

Lift AMX

– Push handle in the “Lift” direction.

– Lift the fork by moving the tiller up and down until you reach the desired lifting

height.

Lower AMX

– Push handle in the “Lower” direction to lower the load.

When moving a laden truck, the handle must be in the neutral (N) position.

AMX-E lift:

Press button (Lift) until you reach the

desired height.

–

AMX-E lower:

– Press “Lower” button to lower the load.

AMX-E tiller:

E 7