Jungheinrich AMX Inox - Returning the Truck to Operation after Decommissioning

F 11
0708.GB
8.3 Returning the truck to operation after decommissioning
– Thoroughly clean the truck.
– Lubricate the truck in accordance with the lubrication schedule (see Chapter F).
– Check hydraulic oil for condensed water and replace if necessary.
– Start up the truck (see Chapter E).
AMX-E only:
– Clean the battery, grease the terminals and connect the battery.
– Charge the battery (see Chapter D).
– Start up the truck (see Chapter E).
Z
Battery powered trucks:
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the operating
controls by applying them repeatedly.
F 11
0708.GB
8.3 Returning the truck to operation after decommissioning
– Thoroughly clean the truck.
– Lubricate the truck in accordance with the lubrication schedule (see Chapter F).
– Check hydraulic oil for condensed water and replace if necessary.
– Start up the truck (see Chapter E).
AMX-E only:
– Clean the battery, grease the terminals and connect the battery.
– Charge the battery (see Chapter D).
– Start up the truck (see Chapter E).
Z
Battery powered trucks:
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the operating
controls by applying them repeatedly.