Jungheinrich AMX Inox - Replacing the Hydraulic Oil (AMX); Replacing the Hydraulic Oil (AMX-E)

0708.GB
F 8
7.2 Replacing the Hydraulic Oil (AMX)
Draining the oil:
– Fork must be in lowered position.
– Tilt pallet truck to the side and remove tank stopper.
– The oil now flows out of the filling hole.
Filling the oil:
– Align pallet truck again and add about 0,7 litres of hydraulic oil.
– The oil must be level with the opening.
– Close opening with tank stopper.
– Pump up the forks fully.
7.3 Replacing the Hydraulic Oil (AMX-E)
Draining the oil:
– Fork must be in lowered position.
– Remove the eight clamps from the oil
container and remove the oil container.
– Empty the oil container and clean the oil
container and filter.
Filling the oil:
– Refit the oil container and fasten with the
eight clamps.
– Add approx. 1.0 l hydraulic oil.
– The oil must be level with the (1) opening.
– Close opening with tank stopper.
– Raise the forks fully.
1
0708.GB
F 8
7.2 Replacing the Hydraulic Oil (AMX)
Draining the oil:
– Fork must be in lowered position.
– Tilt pallet truck to the side and remove tank stopper.
– The oil now flows out of the filling hole.
Filling the oil:
– Align pallet truck again and add about 0,7 litres of hydraulic oil.
– The oil must be level with the opening.
– Close opening with tank stopper.
– Pump up the forks fully.
7.3 Replacing the Hydraulic Oil (AMX-E)
Draining the oil:
– Fork must be in lowered position.
– Remove the eight clamps from the oil
container and remove the oil container.
– Empty the oil container and clean the oil
container and filter.
Filling the oil:
– Refit the oil container and fasten with the
eight clamps.
– Add approx. 1.0 l hydraulic oil.
– The oil must be level with the (1) opening.
– Close opening with tank stopper.
– Raise the forks fully.
1