To Next Page

To Previous Page

1003.GB

Important Information for Transport and Assembly of Hoist Frames

for Reach Trucks

Transport

Depending on the height of the hoist frame and local conditions three different types

of lifts may be undertaken:

– Standing with assembled hoist frame (for low heights)

– Standing with partially assembled hoist frame tilted against the overhead guard (for

average height). Hydraulic hoses for lift function are disconnected

– Standing, with dismantled hoist frame (for large heights) all hydraulic hoses

between the main unit and the hoist frame are disconnected.

Safety Instructions for Assembly and Commissioning

On site assembly of the truck, commissioning and driver instruction shall only be

carried out by staff trained and authorised by the manufacturer.

Only after the lifting equipment has been correctly assembled may the hydraulic

hoses be connected to the main unit / hoist frame interface and the truck put into

operation