To Next Page

To Previous Page

1003.GB

E 6

3 Starting the Truck

Before the truck is started, operated or a load unit raised, the driver must ensure that

there is no one standing in the danger area.

Daily tests and procedures before commencing work

– The entire truck (particularly wheels and lifting devices) to be inspected for

damage.

– Check whether the load chains are evenly tensioned

– Visibly check battery and cable connections

Adjusting the driver’s seat

To achieve optimal seat cushioning the driver’s seat must be adjusted according to

the driver’s weight.

The driver’s seat must not be occupied when being adjusted driver’s weight.

To adjust the driver's weight :

– Pull the lever (9) in the direction of the

arrow and return.

The previous weight setting is reset to

the minimum value

Setting range of seat suspension from

50 kg to 130 kg

– Move lever (9) again in the direction of

the arrow until the corresponding

weight mark on scale (18) is reached.

Then finally return lever.

– Sit on the driver’s seat

From the driver’s seat do not reach out

to the side wall / roof of cab.

Adjust ing the backrest

– Lift up locking lever (10) and adjust the tilt of the backrest (19).

– Release locking lever, the backrest is set

Adjusting the sitting position:

– Pull up the locking lever to locate the driver’s seat (8) in the direction of the arrow

and push the seat forwards or backwards to the desired position.

– Re-engage locking lever (8).

The driver’s seat must be securely located in the desired position. The position of the

driver’s seat must not be altered when driving.

The seat adjustment refers to series standard design. For other designs refer to the

manufacturer’s adjustment instructions.

When adjusting ensure that all controls are within reach