To Next Page

To Previous Page

C 5

1003.GB

Moving the truck without a battery

– Withdraw battery plug.

– Push driver’s seat out of the guide towards the steering wheel.

– Remove fan plug from seat hood.

– Remove seat hood (see Chapter F).

– Remove two-pin plug from magnetic brake

– Remove the brake release screws from the drive plate and insert them into the

holes in the magnetic brake.

The brake is now ventilated without current. The vehicle can be pushed or pulled

without the battery.

After pushing operation is complete the brake release screws must be removed

again.

– Remove the brake release screws from the magnet brake and insert them into the

holes in the drive plate.

– Connect the two-pin plug to the magnet brake.

– Re-fit hood.

– Connect the fan plug to the seat hood.

– Position driver’s seat in guide.

– Connect battery plug.

– Switch on the main switch and key switch

The truck is now ready for use.

5 Commissioning

Before commissining the machine ensure that the hydraulic hoses to the main unit/

hoist frame interface have been connected.

Operate the truck only with battery power! The AC current of the rectifier will damage

electrical components. Connecting cables to the battery (trailing cables) must be less

than 6 metres.

To prepare the machine after delivery or transport the following tasks must be carried

out:

– Install battery (where required). Do not damage battery cable.

– Charge up the battery (see Chapter D).

– Where necessary remove the transport lock for the safety brake

– Operate the truck as described above. (see Chapter E).

If delivered without a battery the truck can only be steered by means of the

mechanical back-up system (see Chapter E).

After commissioning it is possible that slight brake scrubbing noises will be heard.

C 5