30 v1.7 18.06.2020
Restart
WMT will restart
6.2 Create a Device Image Backup
Create an installation USB stick and boot from it (see previous chapter). Select “Cre-
ate System Backup” from “Backup and Restore System”.
Requirements for a Device Image Backup:
Prepared installation USB flash drive without operating system
Enough space on the USB stick depending on the occupied memory space on
the WMT
Deactivated Write Filter (FBWF or UWF)
No additional language packs must have been installed under Windows 10,
otherwise the clone process will fail.
Note that this is not a Clone Master Image Backup. The creation of a Clone Master
Image is discussed in the following chapter. A device image backup represents a
backup of a WMT and can only be restored on the same device. (same serial
number).
Note that the “File Based Write Filter” resp. “Unified File Writer” must be deac-
tivated before performing a backup. In case of non-compliance, a faulty backup
is created.
To Next Page
Loading...
Need help?
General
