7. Place the top portion of the packaging foam on top of the switch.
8. If you are returning accessories or field-replaceable units (FRUs) with the switch, pack them as instructed
in “Packing EX4650 Switch Components for Shipping” on page 143.
9. Place the accessory box vertically by the rear end of the chassis in the shipping carton.
10. Close the top of the cardboard shipping box, and seal it with packing tape.
11. Write the RMA number on the exterior of the box to ensure proper tracking.
Packing EX4650 Switch Components for Shipping
Ensure that you have the following parts and tools available:
•
Antistatic bag, one for each component
•
ESD grounding strap
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not fit together on one level in the shipping box.
To pack the switch components:
1. Place individual components in antistatic bags.
2. Use the original packing materials if they are available. If the original packing materials are not available,
ensure that the component is adequately packed to prevent damage during transit. The packing material
that you use must be able to support the weight of the component.
3. Ensure that the components are adequately protected by wrapping them well with packing materials.
Pack the component in an oversized box (if the original box is not available) with extra packing material
around the unit so that the component does not move inside the box.
4. Securely tape the box closed.
5. Write the RMA number on the exterior of the box to ensure proper tracking.
143
To Next Page
Loading...
Need help?
General
