Juniper EX4650 Series

•
Leave at least 6 in. (15.2 cm) clearance on the left of the chassis for installing the grounding lug.
•
Leave at least 24 in. (61 cm) clearance in front of and behind the switch for service personnel to remove
and install hardware components.
Figure 29: Clearance Requirements for Airflow and Hardware Maintenance for an EX4650 Switch
EX4650 Network Cable and Transceiver Planning
IN THIS SECTION
Pluggable Transceivers Supported on EX4650 Switches | 65
SFP28 Direct Attach Copper Cables for EX4650 Switches | 66
QSFP28 Direct Attach Copper Cables for EX4650 Switches | 68
Calculating the Fiber-Optic Cable Power Budget for EX Series Devices | 69
Calculating the Fiber-Optic Cable Power Margin for EX Series Devices | 69
Pluggable Transceivers Supported on EX4650 Switches
EX4650 switches support SFP, SFP+, and QSFP+ transceivers. You can find the list of transceivers supported
on EX4650 switches and information about those transceivers at the Hardware Compatibility Tool page
for EX4650.
65