residential area is likely to cause harmful interference, in which case users need to correct the interference
at their own expense.
FCC Part 15 Statement
This equipment has been tested and found to comply with the limits for a Class A digital device pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, might cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try and correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio or TV technician for help.
Nonregulatory Environmental Standards
NEBS compliance—These EX Series switches are Network Equipment Building System (NEBS) compliant:
•
EX2200-24T and EX2200-48T
•
EX3200-24T, EX3200-48T
•
EX3300-24T, EX3300-48T
•
EX4200-24T, EX4200-24F, EX4200-24F-S, EX4200-48T and EX4200-48T-S
•
EX4300-24T, EX4300-24T-S, EX4300-24P, EX4300-24P-S, EX4300-32F, EX4300-32F-S, EX4300-48T,
EX4300-48T-AFI, EX4300-48T-S, EX4300-48P, and EX4300-48P-S
•
All EX4500 switches with AC power supplies
•
EX4550-32T-AFO, EX4550-32T-AFI, EX4550-32F-AFO, EX4550-32F-AFI, and EX4550-32F-S
•
EX4600-40F and EX4600-40F-S
•
All EX6200 switches
198
To Next Page
Loading...
Need help?
General
