Juniper JUNOS OS 10.4 - RELEASE NOTES - Page 126

•
LSQ Interface CLI on page 128
•
PT Interface CLI on page 128
•
T1 Interface CLI on page 128
•
VLAN Interface CLI on page 129
Aggregated Interface CLI
•
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
request lacp link-switchover ae0
set interfaces ae0 aggregated-ether-options lacp link-protection
set interfaces ae0 aggregated-ether-options link-protection
ATM Interface CLI
•
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set interfaces at-1/0/0 container-options
set interfaces at-1/0/0 atm-options ilmi
set interfaces at-1/0/0 atm-options linear-red-profiles
set interfaces at-1/0/0 atm-options no-payload-scrambler
set interfaces at-1/0/0 atm-options payload-scrambler
set interfaces at-1/0/0 atm-options plp-to-clp
set interfaces at-1/0/0 atm-options scheduler-maps
set interfaces at-1/0/0 unit 0 atm-l2circuit-mode
set interfaces at-1/0/0 unit 0 atm-scheduler-map
set interfaces at-1/0/0 unit 0 cell-bundle-size
set interfaces at-1/0/0 unit 0 compression-device
set interfaces at-1/0/0 unit 0 epd-threshold
set interfaces at-1/0/0 unit 0 inverse-arp
set interfaces at-1/0/0 unit 0 layer2-policer
set interfaces at-1/0/0 unit 0 multicast-vci
set interfaces at-1/0/0 unit 0 multipoint
Copyright © 2010, Juniper Networks, Inc.126
JUNOS OS 10.4 Release Notes