set interfaces at-1/0/0 unit 0 plp-to-clp
set interfaces at-1/0/0 unit 0 point-to-point
set interfaces at-1/0/0 unit 0 radio-router
set interfaces at-1/0/0 unit 0 transmit-weight
set interfaces at-1/0/0 unit 0 trunk-bandwidth
Ethernet Interfaces
•
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set interfaces ge-0/0/1 gigether-options ignore-l3-incompletes
set interfaces ge-0/0/1 gigether-options mpls
set interfaces ge-0/0/0 stacked-vlan-tagging
set interfaces ge-0/0/0 native-vlan-id
set interfaces ge-0/0/0 radio-router
set interfaces ge-0/0/0 unit 0 interface-shared-with
set interfaces ge-0/0/0 unit 0 input-vlan-map
set interfaces ge-0/0/0 unit 0 output-vlan-map
set interfaces ge-0/0/0 unit 0 layer2-policer
set interfaces ge-0/0/0 unit 0 accept-source-mac
set interfaces fe-0/0/2 fastether-options source-address-filter
set interfaces fe-0/0/2 fastether-options source-filtering
set interfaces ge-0/0/1 passive-monitor-mode
GRE Interface CLI
•
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set interfaces gr-0/0/0 unit 0 ppp-options
set interfaces gr-0/0/0 unit 0 layer2-policer
127Copyright © 2010, Juniper Networks, Inc.
Unsupported CLI
To Next Page
Loading...