NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to connect
your laptop or PC directly to the device, use a combination of the RJ-45 to DB-9 female adapter
supplied with the device and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
To connect the device to a management console (see Figure 57 on page 112 and Figure 58 on page 112):
1. Connect one end of the Ethernet cable to the console port (labeled CON, CONSOLE, or CON1) on the
device.
2. Connect the other end of the Ethernet cable to the console server (see Figure 57 on page 112) or
management console (see Figure 58 on page 112).
Figure 57: Connecting a Device to a Management Console Through a Console Server
g020547
CON
To Console
port Console server
PC
Figure 58: Connecting a Device Directly to a Management Console
Configuring Junos OS on the QFX5120
IN THIS SECTION
QFX5120 Default Configuration | 113
Connecting and Configuring a QFX5120 Switch | 113
112
To Next Page
Loading...
