Juniper QFX5120-48Y-AFO2 Hardware Guide

•
Stop Bits—1
•
DCD State—Disregard
Also gather the following information:
•
Name the switch will use on the network
•
Domain name the switch will use
•
IP address and prefix length information for the Ethernet interface
•
IP address of a default switch
•
IP address of a DNS server
•
Password for the root user
This procedure connects the switch to the network, but does not enable it to forward traffic. For complete
information about enabling the switch to forward traffic, including examples, see the Junos OS configuration
guides.
To configure the software:
1. Verify that the switch is powered on.
2. Log in as the root user. There is no password.
3. Start the CLI.
root# cli
root@>
4. Enter configuration mode.
cli> configure
[edit]
root@#
5. Set the root authentication password by entering either a clear-text password, an encrypted password,
or an SSH public key string (DSA or RSA).
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
114

Juniper QFX5120-48Y-AFO2 Specifications

General

Brand	Juniper
Model	QFX5120-48Y-AFO2
Category	Switch
Language	English