Juniper SRX300 Series User Manual

CHAPTER 14
Replacing Mini-Physical Interface Modules
•
Replacing Mini-Physical Interface Modules on the SRX300 Series and SRX550 High
Memory Services Gateways on page 95
Replacing Mini-Physical Interface Modules on the SRX300 Series and SRX550 High
Memory Services Gateways
Before you begin, power off the services gateway.
CAUTION: The Mini-Physical Interface Modules (Mini-PIMs) available are
not hot-swappable. You must power off the services gateway before removing
or installing Mini-PIMs.
To maintain proper airflow through the services gateway, cover any empty Mini-PIM slot
with a blank faceplate.
CAUTION: Do not remove a blank faceplate unless you are installing a
Mini-PIM in the empty slot.
•
Removing a Mini-Physical Interface Module on page 95
•
Installing a Mini-Physical Interface Module on page 96
•
Removing a Blank Mini-Physical Interface Module Faceplate on page 97
•
Installing a Blank Mini-Physical Interface Module Faceplate on page 97
Removing a Mini-Physical Interface Module
To remove a Mini-PIM from the services gateway:
1. Place an electrostatic bag or antistatic mat on a flat, stable surface on which you
intend to place the Mini-PIM.
2. Attach an ESD grounding strap to your bare wrist, and connect the strap to the
grounding point on the back of the device.
95Copyright © 2017, Juniper Networks, Inc.

Juniper SRX300 Series Specifications

General

Memory	4 GB
CPU	Intel Atom
Storage	8 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% noncondensing