17
Chapter 2
Installing and Connecting the Device
This chapter describes how to mount an SSG 5 device and connect cables and
power to the device. This chapter contains the following sections:
“Before You Begin” on page 18
“Installing Equipment” on page 18
“Connecting Interface Cables to a Device” on page 19
“Connecting the Power” on page 20
“Connecting a Device to a Network” on page 20
NOTE: For safety warnings and instructions, refer to the Juniper Networks Security
Products Safety Guide. Before working on any equipment, you should be aware of
the hazards involved with electrical circuitry and familiar with standard practices
for preventing accidents.
To Next Page
Loading...
