Juniper SSG 5 Serial - Eth0;0 Interface (Untrust Zone) Window

 55
7. Eth0/0 Interface (Untrust Zone) Window
The Untrust zone interface can have a static or a dynamic IP address assigned via
DHCP or PPPoE. Insert the necessary information, then click Next.
Figure 26: Eth0/0 Interface Window
Table 15: Fields in Eth0/0 Interface Window
Field Description
Dynamic IP via DHCP Enables the device to receive an IP address for the Untrust zone
interface from a service provider.
Dynamic IP via PPPoE Enables the device to act as a PPPoE client, receiving an IP address
for the Untrust zone interface from a service provider. Enter the
username and password assigned by the service provider.
Static IP Assigns a unique and fixed IP address to the Untrust zone interface.
Enter the Untrust zone interface IP address, netmask, and gateway.