SSG 5 Hardware Installation and Configuration Guide
26 Accessing a Device
Figure 11: WebUI Login Prompt
4. If you have not yet changed the default login for the admin name and
password, enter
netscreen at both the login and password prompts. (Use
lowercase letters only. The login and password fields are both case-sensitive.)
Using Telnet
To establish a Telnet connection, perform the following steps:
1. Connect your workstation to the 0/2 — 0/6 port (bgroup0 interface in the Trust
zone) on the device.
2. Ensure that your workstation is configured for DHCP or is statically configured
with an IP address in the 192.168.1.0/24 subnet.
3. Start a Telnet client application to the IP address for the bgroup0 interface (the
default IP address is 192.168.1.1). For example, enter
telnet 192.168.1.1.
The Telnet application displays the login prompt.
4. If you have not yet changed the default user name and password, enter
netscreen at both the login and password prompts. (Use lowercase letters only.
The login and password fields are both case-sensitive.)
5. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To remove the timeout, enter
set console timeout 0.
To Next Page
Loading...
