Juniper SSG 5 Serial - Eth0;1 Interface (DMZ Zone) Window; Bgroup0 Interface (Trust Zone) Window

SSG 5 Hardware Installation and Configuration Guide
56 
8. Eth0/1 Interface (DMZ Zone) Window
The DMZ interface can have a static or a dynamic IP address assigned via DHCP.
Insert the necessary information, then click Next.
Figure 27: Eth0/1 Interface Window
Table 16: Fields in Ethernet0/1 Interface Window
9. Bgroup0 Interface (Trust Zone) Window
The Trust zone interface can have a static or a dynamic IP address assigned via
DHCP. Insert the desired information, then click Next.
The default interface IP address is 192.168.1.1 with a netmask of 255.255.255.0 or
24.
Field Description
Dynamic IP via DHCP Enables the device to receive an IP address for the DMZ interface
from a service provider.
Static IP Assigns a unique and fixed IP address to the DMZ interface. Enter
the DMZ interface IP address and netmask.