17
a[IEEE1394] IEEE1394 switch
Set according to the image format of the input/output sig-
nal and playback signal of the IEEE1394 terminal.
HDV : Set to this for HDV format and 1080I CAMERA
ON.
DV : Set to this for DV format.
b[Y/P
B/PR] Component Y/PB/PR signal output terminal
(BNC × 3)
Outputs analog component (Y/P
B/PR) signals.
• Select whether or not to add setup signals to DV format
signals in SET UP item on the VIDEO FORMAT[2/2]
menu screen. (Only for U model)
• Set ANALOG OUT CHAR. item on the OTHERS[1/2]
menu screen to ON to output menu setting screens and
warnings from this terminal.
c[REMOTE] REMOTE terminal (Round 6-pin)
Some functions of this camera can be controlled exter-
nally.
Connect to a remote control unit (RM-LP55/RM-LP57/RM-
LP25).
X See “Connect a Remote Control Unit (RM-LP55/RM-
LP57/RM-LP25)” on page 68.
d[DC INPUT] DC input terminal (XLR 4-pin)
This is the 12V DC power input terminal. Connect to the
AC adapter.
When a battery is installed and a cable is connected to this
terminal, power supply from the battery stops and power is
supplied by this terminal.
IEEE 1394
CH2-AUDIO OUT-CH1 VIDEO
b
c
d
a
e_hd200.book Page 17 Friday, February 1, 2008 4:04 PM
To Next Page
Loading...
