25
STATUS 1
In addition to the information on the STATUS 0 screen, this screen displays the following items.
STATUS 1 Screen
12
3
4
8
9
0
7
65a
No. Item Contents
1 VIDEO FORMAT display Displays the currently selected video format.
Allows you to select the REC item on the VIDEO FORMAT[1/2] menu screen. X See page 74.
You can switch this display ON/OFF using the VIDEO FORMAT item on the LCD/VF[3/4] menu screen.
X See page 88.
2 Time Code (TC)/User’s Bits
(UB) indication
Indicates the time code (h:m:s:frame) or user’s bits data.
Whether or not to display this item is set with the TC/UB item on the LCD/VF[3/4] menu screen.
X See page 88.
Whether the time code or user’s bits should be shown is selected with the TC DISPLAY switch inside the
LCD door.
3 Remaining tape indication Remaining tape indication (displayed in 1-minute steps)
This indicator blinks when remaining tape time is equivalent to less than 3 minutes.
Whether or not to display this item is set with the TAPE REMAIN item on the LCD/VF[3/4] menu screen.
X See page 88.
* When inserting a brand-new tape, the remaining tape time is not indicated.
When the tape has been run, the indication will appear.
* The remaining tape indication is to be regarded only as a guide.
* When this device is used at low temperatures, it may take a while before the indication of the remaining
tape time appears.
4 Voltage indication (Example) 12.2V: Indicates remaining battery level in 0.1V steps.
Battery voltage and remaining battery are displayed. Select the display method in BATTERY INFO. on the
LCD/VF[3/4] menu screen. X See page 88.
Anton Bauer battery: Voltage/remaining capacity (%)/remaining time
IDX Endura battery : Voltage/remaining capacity (%)
(Example) Time code TC 00 : 00 : 00 : 00
User’s bits UB FF EE DD 20
Colon (:) when non-drop frame mode
Dot (.) when drop frame mode
e_hd200.book Page 25 Friday, February 1, 2008 4:04 PM
To Next Page
Loading...
