JVC GY-HM250E - Deleting Clips

Time Code Playback
Time code or
user’s bit recorded on an SD card can
be displayed on the LCD monitor and viewfinder.
Memo :
0
The time code is also superimposed on the
video
signal
output
from the [SDI OUT] terminal.
0
If a section without time code is played back, the
time code will stop. However, playback will
continue.
Displaying Information during Shooting
Pressing the [DISPLAY] button during playback
displays the display screen.
Pressing the [
OIS/6] button each time changes the
shooting information displayed (camera
information display and hide display).
0
Camera information display displays only
information of Gain, Iris, Shutter and White
Balance that have been recorded.
.
P 13000K
1/100
F1. 6
0
dB
Camera Information Display
Memo :
0
When [System] B [Record Set] B [Record
Format] B
System is set to “HD+Web”, only SD
or web files can be played back from slot B.
In this case, files up-converted into the HD size
are played back in the simple mode.
0
Trimming information is displayed while
trimming
is in
progress. In this case, pressing the
[OIS/6] button does not switch the display.
Deleting Clips
Delete clip.
.
Memo :
0
Clips appended with OK marks cannot be
deleted on the camera recorder.
0
Read-only clips can be deleted on a PC.
Deleting One Clip
Delete the clip (one clip) pointed by the cursor in
[Delete Clips]
B [This Clip] in the menu.
Memo :
0
Clips with OK mark cannot be deleted.
During Thumbnail Screen
1
Move the cursor to the clip to be deleted.
Move the cursor to the clip to be deleted using
the cross-shaped button (JKH I).
.
218G0005
1
2015-01-07 07:08:43
2
Press the [ZEBRA/5] button.
The action selection screen is displayed.
92
Playing Recorded Clips
Playback