JVC GZ-HD3U - Menu Settings: Image Brightness and White Balance; Adjusting Brightness and Shutter Speed; Aperture Priority and White Balance

m[AUTO]: White balance is adjusted automatically.
~ MWB: Adjusts the white balance manually depending on the
light source.
1) Hold a sheet of plain white paper in
front of the subject so that the white
paper fills the screen.
2) Press and hold the set lever until the
~ indicator starts blinking then stops
blinking.
.
:,:- FINE: When shooting outdoors on a sunny day.
& CLOUD: When shooting outdoors on a cloudy day.
!ft HALOGEN: When a video light or similar type of lighting is used.
[AUTO]: The aperture value is adjusted automatically.
F1.8 to F8 (For" mode) I
F1.9 to F5.6 (For 0 mode):
The lower the F-number (larger aperture value), the more
blurred the background will become. The higher the F-number
(smaller aperture value), the clearer the focus will be for both
near and far objects. Move the set lever to
A / v to set the
value.
IImD
If the image is too bright, set to a larger F-number. If the image is too
dark, set
to a smaller F-number.
[AUTO]: The shutter speed is adjusted automatically.
1/2 to 1/4000:
The smaller the value, the faster the shutter speed. Move the
set lever to
A / v to set the value.
IImD
It is recommended to use a tripod (u pg. 18) when recording with a
slow shutter speed.
For" mode
[AUTO]: The brightness is adjusted automatically.
-6 to +6: Corrects the brightness within this range in increments
of
1. Move the set lever to A / v to set the value.
ForO mode
[±O]: The brightness is not adjusted.
-2.0 to +2.0 (EV): Corrects the brightness within this range in
increments of 1/3EV. Move the set lever to
A / v to set the
value.
• To lock the exposure
When the menu disappears after you finish configuring the
setti~, press and hold the set lever for more than 2 seconds.
The
~ indicator appears.
27