Troubleshooting
The
camera is a microcomputer-controlled
device. External noise and interference (from
a
TV,
a radio, etc.) might prevent it from
functioning properly.
The
following
phenomena
are
not
malfunctions.
• The camera heats up when it is used for a
long time.
•
The
battery heats up during charging.
•
When
playing back a video file, the
image stops momentarily
or
the sound is
interrupted at junctions between scenes.
•
To
solve the problem, first follow the
instructions below.
• If the problem is not solved, reset the
camera.
(0'
below)
.If
the problem persists, please consult your
nearest JVC dealer.
• To reset
the
camera
1)
Set the power/mode switch to OFF and
remove the power supply (battery pack
or
AC adapter) from the camera, then
reattach it.
2) Execute [PRESET] from the menu.
(0'
pg. 69)
, .'."
.,'
. .... ' • Connect the
AC
adapter securely.
.No
po\y~ri$sllPp!ieCt:.:
• Detach the battery pack once and re-attach it firmly.
. . .
..
, , , . . .
..
• Replace the dead battery with a fully charged one.
• If the camera
is
not operated for 5 minutes while the
power
is
on,
it
turns itself off automatically to conserve
power.
To
turn the camera
on
again when using the
battery pack, set the power/mode switch to OFF, then to
ON. When using the
AC
adapter, perform any operation
such as zooming.
• Adjust the brightness of the LCD monitor. 69
• Move to a place where not affected by vibration or
excessive sound.
• The drop detection function operated. Set the power/ 69
mode switch to OFF, and to
ON
again.
To
turn off this
function, set [DROP DETECTION] to [OFF].
• Fully charge the battery, and then
run
it
down.
If
the 16
problem persists, the battery
is
worn out and needs
to
be
replaced. Please purchase a new one.
• Make sure to use the camera under appropriate operating 79
temperatures.
• The battery
is
worn out and needs to
be
replaced. Please
purchase a new one.
• Charging may stop
in
places subject to extremely
high/low temperatures to protect the battery. It
is
recommended to charge it
in
places with a temperature
of 10°C to 35°C (50°F to 95°F).
• When the battery
is
already fully charged, the lamp does 18
not light. Check the remaining battery power.
73
To Next Page
Loading...
