Connecting
the
Camera
to
the
PC
• When you have finished operation
Always follow the procedures below when
disconnecting the camera, or turning off the
camera/PC power.
Failing to do so may cause damage to the
camera and
PC.
1) Confirm that the access/charge lamp on
the camera does not light or blink.
(If the access/charge lamp lights or
blinks, wait until it is turned off before
proceeding.)
2) Double-click the [Safely Remove
Hardware] or [Unplug or Eject Hardware]
icon in the status bar.
3) Select [USB Mass Storage Device]
or
[USB Disk], and then click [Stop].
4) Click [OK].
5) Disconnect the USB cable.
6)
Turn off the camera and PC.
•
To
AC Outlet
USB Cable
AC Adapter
USB Connector
Preparation:
Set the camera's power/mode switch to OFF.
USB Connector
IImDD
• Never disconnect the USB cable while the
access/charge lamp on the camera lights or
blinks.
• Do not turn off the camera when the USB
cable is connected, to prevent malfunctions
of the PC.
• Connect the camera directly to the PC, not
through a hub.
• Do not use an extension USB cable.
• When you copy files from the
PC
to the
recording medium on the camera, do not
include any other files than those recorded
on the camera.
• Do not delete, move,
or
rename the files and
folders
in
the camera from the
PC.
55
To Next Page
Loading...
