Warning Indications
---+~
c:::J
Exhausted
• Appears when an incompatible USB device
is
connected to
the camera.
• Appears when the connected
DVD
burner is switched off. If
you want to use the
DVD
burner, switch the power on.
• The writing speed of recording medium is slow, or the 19
recording medium is corrupted. Use an
SO
card that is
guaranteed to operate correctly.
• The hard disk was subjected to vibrations or jolts.
Be
careful
not to subject the hard disk to vibrations or jolts.
• Appears when the recording medium is full and recording 37
is not possible. Delete unnecessary files, or replace the
SO
card.
• Appears when the event information cannot be read. 40
Register the file to
an
event.
• The video management file
is
broken. Recovery is required
to record or play back video files. Move the set lever to
A /
v to select [YES], then press down to recover the video
management file.
• Appears when you attempt recording when the write/erase 37
protection tab on the
SO
card
is
set to the "LOCK" position.
•
Perform
clean
up
to restore the capacity
of
the recording
media.
71
• Turn off the camera. Remove the card and insert it again. 19
Turn
on
the camera after inserting the
SO
card. If the error
message appears again, replace the card with one that is
certified to operate correctly.
• Appears for 5 seconds after power
is
turned on
in
recording
mode if the lens cover
is
closed or when it
is
dark.
• Appears when the date/time
is
not set. 17
• The built-in clock's rechargeable lithium battery
is
16
discharged, so the previously set date/time
is
erased.
Connect the camera to an
AC
outlet using the
AC
adapter
for over 24 hours to charge the clock's lithium battery. Then
set the date/time.
• As the battery power comes close to nil, the battery
indicator blinks. When the battery power
is
exhausted,
power turns off automatically.
• Displays the remaining battery power.
[--I
~[-I
~~
High
77
To Next Page
Loading...
